Skip to content
ELM Lampret
Residential installations

Your home,wired right.

Our core work: electrical installations for new builds and renovations — from the main run to the last socket.

Napeljava in doze v armaturi pred betoniranjem

New builds

The complete installation from panel to the last socket: wiring runs, circuits, lighting and low-voltage. Everything ready for measurement and a report at handover.

Utori v steni z novimi cevmi med adaptacijo

Renovations

Old wiring renewed without unnecessary demolition. A new panel, earthing and circuits that can handle today's appliances.

Dnevna soba z lesenim stropom, vgrajenimi svetili in LED trakom

Fitting & connections

Lights, cookers, water heaters, heat pumps. Supplied from our shop or your own fittings installed.

Smart home · KNX and Loxone

Fewer switches,more control.

Automatic functions, fewer switches and each one where it belongs, logic and full control. Every smart installation comes together under one roof — with Home Assistant, your own projects too.

How a command travels
  1. 01

    Button or sensor

    press, temperature, presence, weather

  2. 02

    KNX bus

    the telegram reaches the right devices

  3. 03

    Actuator in the board

    switch, dim, drive

  4. 04

    Light, blind, heating

    status shown on the button or your phone

KNX distribution board with actuators for lighting, shading and heating
KNX

The oldest and most proven smart-installation protocol. Hundreds of manufacturers, thousands of products, decentralised programming and the highest level of safety and reliability.

Loxone

A new approach to home automation: you decide what you want and what you don't. The software is free, so you can take part in the setup yourself and shape the system around your habits.

Loxone Silver Partner certificate — ELM Lampret d.o.o.
Loxone Silver Partner

Certified for planning, configuration, installation and sales of Loxone home automation.

What you get
  1. 01Consulting and a home-automation plan
  2. 02Board preparation and programming
  3. 03KNX components programmed in advance — ready to install
  4. 04Lighting, shading, heating and energy connected
How it works

Four steps,no surprises.

  1. 01

    Site visit

    We come, take a look and talk through what you need.

  2. 02

    Quote

    You get a clear quote — what, by when and for how much.

  3. 03

    The work

    We do the job and clean up after ourselves.

  4. 04

    Measurement & report

    We measure the installation and hand it over with a report.

Buildingor renovating?

Send a floor plan or just describe what you're doing — we'll tell you how we'd approach it and when we can visit.